H3C MSR3600 - LED Description Details

1-42
MSR3600-51-G-DP
Figure1-95 MSR3600-51-G-DP LEDs
(1) Gigabit Ethernet copper port LEDs (GE5 to GE52)
(2) Gigabit Ethernet copper port LED (GE0)
(3) SFP+ port LEDs (SFP+53 and SFP+54)
(4) Gigabit Ethernet copper port LEDs (GE1 to
GE4)
(5) Power supply LED (PWR2)
(6) Power supply LED (PWR1)
(7) System status LED (SYS)
LED description
IMPORTANT:
•
The SFP28 ports on the MSR3600-28-X1, MSR3600-28-XS, or MSR3600-28-X1-
DP router and
SFP52 ports on the MSR3600-51-X1 or MSR3600-51-X1-DP router can operate only at 1000
Mbps.
•
The SFP+16 and SFP+17 ports on the MSR3620-X1 or MSR3620-X1-XS router does not
support operating at 1000 Mbps.
•
The SFP+9 to SFP+11 ports on the MSR3640-X1 or MSR3640-XS router does not support
operating at 1000 Mbps.
•
The SFP+10 port on the MSR3610E-X1 or MSR3610E-X1-
DP router does not support operating
at 1000 Mbps.
Table1-1 LED description
LED State Description
SYS
Flashing green (8 Hz) The BootWare is running.
Steady green The SDRAM is performing self-test.
Flashing green (1 Hz)
Comware has started with the configuration file and the
router has booted up.
Flashing yellow (1 Hz) The DDR3 SDRAM has failed the self-test.
Flashing yellow (8 Hz) The extended segment does not exist.
Steady yellow The boot image does not exist.
Off No power input, or exceptions have occurred.
Flashing green (8 Hz) USB-based automatic configuration has succeeded.
Flashing yellow (8 Hz) USB-based automatic configuration has failed.
SYS (applicable to
MSR3610-X1/MSR3
Flashing green (1 Hz)
Comware has started with the configuration file and the
device has booted up.
4
3
1
2
567