H3C S5120-EI Series - Page 64

4-9
* *
***********************************************************
Copyright (c) 2004-2009 Hangzhou H3C Tech. Co., Ltd.
Creation date : May 7 2009, 09:06:06
CPU Clock Speed : 264MHz
BUS Clock Speed : 33MHz
Memory Size : 128MB
Mac Address : 000fe2d258fb
Press Ctrl-B to enter Boot Menu... 5
In normal startup mode, the waiting time here is five seconds. If you press Ctrl + B within five seconds,
the Boot Menu is displayed. If you press Ctrl + B within five seconds, the Boot Menu is displayed: If you
perform no operation or press a key other than Ctrl + B within five seconds, the system begins to
automatically start up and the following information is displayed:
Auto-booting...
Decompress Image................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
...........................................OK!
Board checking.......................LSP1LTSUD
SDRAM fast selftest........................OK!
Flash fast selftest........................OK!
CPLD selftest..............................OK!
Switch chip selftest.......................OK!
PHY selftest...............................OK!
Please check leds....................FINISHED!
User interface aux0 is available.
Press ENTER to get started.