7
11.1.1.0/24 Static 60 0 0.0.0.0 NULL0
# Display route entries by specifying a destination IP address and mask.
[Sysname] display ip routing-table 11.1.1.1 24
Routing Table : Public
Summary Count : 3
Destination/Mask Proto Pre Cost NextHop Interface
11.0.0.0/8 Static 60 0 0.0.0.0 NULL0
11.1.0.0/16 Static 60 0 0.0.0.0 NULL0
11.1.1.0/24 Static 60 0 0.0.0.0 NULL0
# Display route entries by specifying a destination IP address and mask and the longer-match keyword.
[Sysname] display ip routing-table 11.1.1.1 24 longer-match
Routing Table : Public
Summary Count : 1
Destination/Mask Proto Pre Cost NextHop Interface
11.1.1.0/24 Static 60 0 0.0.0.0 NULL0
For detailed description of the output, see Table 2.
# Display route entries for destination addresses in the range 1.1.1.0 to 5.5.5.0.
<Sysname> display ip routing-table 1.1.1.0 24 5.5.5.0 24
Routing Table : Public
Destination/Mask Proto Pre Cost NextHop Interface
1.1.1.0/24 Direct 0 0 1.1.1.1 Vlan1
1.1.1.1/32 Direct 0 0 127.0.0.1 InLoop0
2.2.2.0/24 Direct 0 0 2.2.2.1 Vlan2
3.3.3.0/24 Direct 0 0 3.3.3.1 Vlan2
3.3.3.1/32 Direct 0 0 127.0.0.1 InLoop0
4.4.4.0/24 Direct 0 0 4.4.4.1 Vlan1
4.4.4.1/32 Direct 0 0 127.0.0.1 InLoop0
display ip routing-table protocol
Syntax
display ip routing-table protocol protocol [ inactive | verbose ] [ | { begin | exclude | include }
regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
protocol: Routing protocol. It can be direct, static.
inactive: Displays information about only inactive routes. With this argument absent, the command
displays information about both active and inactive routes.
To Next Page
Loading...
Need help?
General