H3C S5120-EI Series - Display Ipv6 Routing-Table

10
display ipv6 routing-table
Syntax
display ipv6 routing-table [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, which is a case sensitive string of 1 to 256 characters.
Description
Use the display ipv6 routing-table command to display brief routing table information, including
destination IP address and prefix, protocol type, priority, metric, next hop and outbound interface.
The command displays only active routes (the brief information about the current optimal routes).
Examples
# Display brief routing table information
<Sysname> display ipv6 routing-table
Routing Table :
Destinations : 1 Routes : 1
Destination : ::1/128 Protocol : Direct
NextHop : ::1 Preference : 0
Interface : InLoop0 Cost : 0
Table 4 Output description
Field Description
Destination IPv6 address of the destination network/host
NextHop Nexthop address
Preference Route priority
Interface Outbound interface
Protocol Routing protocol
Cost Route cost