H3C S5120-EI Series - Static Routing Configuration Commands; Delete Static-Routes All; Ip Route-Static

18
Static routing configuration commands
NOTE:
The term
router in this document refers to both routers and Layer 3 switches.
Static routing configuration commands
delete static-routes all
Syntax
delete static-routes all
View
System view
Default level
2: System level
Parameters
None
Description
Use the delete static-routes all command to delete all static routes.
When you use this command to delete static routes, the system will prompt you to confirm the operation
before deleting all the static routes.
Related commands: ip route-static and display ip routing-table.
Examples
# Delete all static routes on the router.
<Sysname> system-view
[Sysname] delete static-routes all
This will erase all ipv4 static routes and their configurations, you must reconfigure all
static routes
Are you sure?[Y/N]:Y
ip route-static
Syntax
ip route-static dest-address { mask | mask-length } { next-hop-address [ track track-entry-number ] |
interface-type interface-number [ next-hop-address ] } [ preference preference-value ] [ description
description-text ]
undo ip route-static dest-address { mask | mask-length } [ next-hop-address | interface-type
interface-number [ next-hop-address ] ] [ preference preference-value ]