H3C S5120-EI Series - Irf-Port

16
To return to the CLI of the master switch, use the quit command.
Examples
# Log in to the CLI of IRF member switch 2.
<Sysname> system-view
[Sysname] irf switch-to 2
<Sysname-Slave#2>
irf-port
Syntax
irf-port member-id/port-number
undo irf-port member-id/port-number
View
System view
Default level
3: Manage level
Parameters
member-id/port-number: IRF port number, where member-id represents the ID of the IRF member switch.
The port-number argument specifies the port number, and the value can be 1 or 2.
Description
Use the irf-port command to create an IRF port and enter IRF port view. If the IRF port is already created,
you enter IRF port view directly.
Use the undo irf-port command to delete an IRF port.
By default, no IRF port is created on the switch.
IRF ports are virtual ports. An IRF port is available only after you bind a physical port to it.
Related commands: port group interface.
Examples
# Create IRF port IRF-port 1 for IRF member switch 3, and bind this port to physical IRF port
Ten-GigabitEthernet 3/1/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 3/1/1
[Sysname-Ten-GigabitEthernet3/1/1] shutdown
[Sysname-Ten-GigabitEthernet3/1/1] quit
[Sysname] irf-port 3/1
[Sysname-irf-port3/1] port group interface ten-gigabitethernet 3/1/1
[Sysname-irf-port3/1] quit
[Sysname] interface ten-gigabitethernet 3/1/1
[Sysname-Ten-GigabitEthernet3/1/1] undo shutdown