EasyManuals Logo

H3C WA2600 Enhanced Series Command Reference

H3C WA2600 Enhanced Series
131 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #122 background imageLoading...
Page #122 background image
12-32
ipv6 neighbor
Syntax
ipv6 neighbor ipv6-address mac-address { vlan-id port-type port-number | interface interface-type
interface-number }
undo ipv6 neighbor ipv6-address interface-type interface-number
View
System view
Default Level
2: System level
Parameters
ipv6-address: IPv6 address in a static neighbor entry.
mac-address: Link layer address in a static neighbor entry (48 bits long, in the format of H-H-H).
vlan-id: VLAN ID in a static neighbor entry, in the range of 1 to 4094.
port-type port-number: Type and number of a Layer 2 port in a static neighbor entry.
interface interface-type interface-number: Type and number of a Layer 3 interface in a static neighbor
entry.
Description
Use the ipv6 neighbor command to configure a static neighbor entry.
Use the undo ipv6 neighbor command to remove a static neighbor entry.
Note that you can adopt the IPv6 address and link layer address of the Layer 3 VLAN interface or those
of the VLAN port to configure a static neighbor entry.
z If a static neighbor entry is configured by using the first method, the neighbor entry is in the INCMP
state. After the AP obtains the corresponding Layer 2 VLAN port information through resolution, the
neighbor entry will go into the REACH state.
z If a static neighbor entry is configured by using the second method, the corresponding VLAN
interface must exist and the port specified by port-type port-number must belong to the VLAN
specified by vlan-id. After a static neighbor entry is configured, the AP will relate the VLAN interface
with the IPv6 address to identify a static neighbor entry uniquely and the entry will be in the REACH
state.
You only need to specify the corresponding VLAN interface before removing a static neighbor entry.
Related commands: display ipv6 neighbors.
Examples
# Configure a static neighbor entry for Layer 2 port Ethernet 1/0 of VLAN 100.
<Sysname> system-view
[Sysname] ipv6 neighbor 2000::1 fe-e0-89 100 ethernet 1/0
ipv6 neighbors max-learning-num
Syntax
ipv6 neighbors max-learning-num number
undo ipv6 neighbors max-learning-num

Table of Contents

Other manuals for H3C WA2600 Enhanced Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C WA2600 Enhanced Series and is the answer not in the manual?

H3C WA2600 Enhanced Series Specifications

General IconGeneral
BrandH3C
ModelWA2600 Enhanced Series
CategoryWireless Access Point
LanguageEnglish

Related product manuals