5-5
undo dhcp server detect
View
System view
Default Level
2: System level
Parameters
None
Description
Use the dhcp server detect command to enable unauthorized DHCP server detection.
Use the undo dhcp server detect command to disable the function.
By default, the function is disabled.
With this function enabled, upon receiving a DHCP request, the DHCP server will record the IP
addresses of DHCP servers which ever offered IP addresses to the DHCP client and the receiving
interface. Each server detected is recorded only once. The administrator can get this information from
logs to check out unauthorized DHCP servers.
Examples
# Enable unauthorized DHCP server detection.
<Sysname> system-view
[Sysname] dhcp server detect
dhcp server forbidden-ip
Syntax
dhcp server forbidden-ip low-ip-address [ high-ip-address ]
undo dhcp server forbidden-ip low-ip-address [ high-ip-address ]
View
System view
Default Level
2: System level
Parameters
low-ip-address: Start IP address of the IP address range to be excluded from dynamic allocation.
high-ip-address: End IP address of the IP address range to be excluded from dynamic allocation. The
end IP address must have a higher sequence than the start one.
Description
Use the dhcp server forbidden-ip command to exclude IP addresses from dynamic allocation.
Use the undo dhcp server forbidden-ip command to remove the configuration.
By default, all IP addresses in a DHCP address pool are assignable except IP addresses of the DHCP
server interfaces.
Note that:
To Next Page
Loading...
Need help?
General
