H3C WA2600 Enhanced Series Command Reference

12-7
Parameters
ipv6-address: IPv6 address whose neighbor information is to be displayed.
all: Displays information of all neighbors, including neighbors acquired dynamically and configured
statically.
dynamic: Displays information of all neighbors acquired dynamically.
static: Displays information of all neighbors configured statically.
interface interface-type interface-number: Displays information of the neighbors of a specified
interface.
vlan vlan-id: Displays information of the neighbors of a specified VLAN whose ID ranges from 1 to
4094.
|: Uses a regular expression to match neighbor entries. For detailed information about regular
expression, see CLI in the Fundamentals Configuration Guide.
begin: Displays a specific neighbor entry and all the neighbor entries following it. The specific neighbor
entry must match the specified regular expression.
include: Displays the neighbor entries matching the specified regular expression.
exclude: Displays the neighbor entries not matching the specified regular expression.
regular-expression: A case-sensitive string of 1 to 256 characters.
Description
Use the display ipv6 neighbors command to display neighbor information.
You can use the reset ipv6 neighbors command to clear specific IPv6 neighbor information.
Related commands: ipv6 neighbor and reset ipv6 neighbors.
Examples
# Display all neighbor information.
<Sysname> display ipv6 neighbors all
Type: S-Static D-Dynamic
IPv6 Address Link-layer VID Interface State T Age
FE80::200:5EFF:FE32:B800 0000-5e32-b800 N/A Eth1/0/1 REACH S -
Table 12-4 display ipv6 neighbors command output description
Field Description
IPv6 Address IPv6 address of a neighbor
Link-layer Link layer address (MAC address of a neighbor)
VID VLAN to which the interface connected with a neighbor belongs
Interface Interface connected with a neighbor
State
State of a neighbor, including:
z INCMP: The address is being resolved. The link layer address of the neighbor
is unknown.
z REACH: The neighbor is reachable.
z STALE: The reachability of the neighbor is unknown. The device will not verify
the reachability any longer unless data is sent to the neighbor.
z DELAY: The reachability of the neighbor is unknown. The device sends an NS
message after a delay.
z PROBE: The reachability of the neighbor is unknown. The device sends an NS
message to verify the reachability of the neighbor.

H3C WA2600 Enhanced Series Specifications

General

Brand	H3C
Model	WA2600 Enhanced Series
Category	Wireless Access Point
Language	English