14-19
By default, you can log in to the device through the console port without authentication and have user
privilege level 3 after login. The network requirements are as follows:
z Authenticate users logging in to VTY 0 using a local password.
z Set the local password to 123456 (in plain text).
z Commands of level 2 are available to users logging in to VTY 0.
z Telnet is supported.
z The screen can contain up to 30 lines.
z The history command buffer can contain up to 20 commands.
z The timeout time of VTY 0 is 6 minutes.
2) Network diagram
Figure 14-14 Network diagram for Telnet configuration (with the authentication mode password)
3) Configuration procedure
# Enter system view.
<Sysname> system-view
# Enter VTY 0 user interface view.
[Sysname] user-interface vty 0
# Enable password authentication for users that log in to VTY 0.
[Sysname-ui-vty0] authentication-mode password
# Set the local password to 123456 (in plain text).
[Sysname-ui-vty0] set authentication password simple 123456
# Specify commands of level 2 are available to users that log in to VTY 0.
[Sysname-ui-vty0] user privilege level 2
# Configure VTY 0 to support Telnet.
[Sysname-ui-vty0] protocol inbound telnet
# Set the maximum number of lines the screen can contain to 30.
[Sysname-ui-vty0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[Sysname-ui-vty0] history-command max-size 20
# Set the timeout time to 6 minutes.
[Sysname-ui-vty0] idle-timeout 6
To Next Page
Loading...
Need help?
General
