2-1
2 Installing the AP
Installation flowchart
Figure2-1 Installation flowchart
Pre-installation tasks
Before installing the AP, perform the following tasks:
Connect the AP to a power source and the network. Examine the LEDs to verify that the AP is
operating correctly. For information about AP LEDs, see "Appendix B LEDs and ports".
Record the MAC address and serial number at the rear of the AP for future use.
Make sure you have completed cabling at the installation site.
Use Cat-5e or above network cables. For information about the supported interface rates, see
"Appendix B LEDs and ports".
The AP is typically installed on a high position. As a best practice, access and configure the AP
before installing it.
If a cable is routed outdoors, make sure a lighting arrester is attached to the AP port. Prepare a
lighting arrester yourself as needed.
To Next Page
Loading...
Need help?
General
