H3C WX User Manual

3-7
Feature Matrix for the WX6000 Series
The switch interface module on the WX6103, and the LSQM1WCMB0, LSBM1WCM2A0, and LSRM1WCM2A1 access controller modules on the WX6000
series adopt the OAP architecture. Installed on the expansion slots of switches, they work as OAP cards to exchange data and status and control information
with the switches through their internal service interfaces. The XGE interfaces on the switch interface module on the WX6103, and the LSQM1WCMB0,
LSBM1WCM2A0, and LSWM1WCM10 access controller modules are internal interfaces. Do not configure services such as QoS rate limiting and 802.1X
authentication on them.
Table 3-2 Feature matrix for the WX6000 series
Volume Module Feature WX6103 LSQM1WCMB0 LSBM1WCM2A0 LSRM1WCM2A1
AUX user interface No No No Yes
Console user interface Yes Yes Yes Yes
Login configuration
Telnet Yes Yes
Yes (IPv6 telnet not
supported)
Yes
User interface
configuration
User interface type
AUX user interface
not supported
AUX user interface
not supported
AUX user interface
not supported
AUX user interface
not supported
File management
configuration
Configuration file
encryption
No No No No
Storage media supported CF and USB CF and USB CF and USB CF and USB
Fundamentals
Configuration Guide
Device management
configuration
License
128 APs at most by
default, and can be
extended to 640
APs.
128 APs at most by
default, and can be
extended to 640
APs.
128 APs at most by
default, and can be
extended to 640
APs.
128 APs at most by
default, and can be
extended to 640
APs.
WLAN Configuration WLAN services
Hot AC backup Yes Yes Yes Yes

H3C WX Specifications

General

Brand	H3C
Model	WX
Category	Controller
Language	English