To Next Page

To Previous Page

6-3

Configuration Examples

Configuring LS8M1WCMA0

Network requirements

An access controller module LS8M1WCMA0 is inserted in slot 4 of the switch. Packets on VLAN 1,

VLAN 8, VLAN 9, and VLAN 10 are permitted to transfer between the module and the switch. By default,

packets on VLAN 1 are permitted to transfer between the module and the switch.

Configuration procedure

1) Configure the switch

<Switch>system-view

# Create VLAN 8 through VLAN 10.

[Switch]vlan 8 to 10

# Create a manual aggregation group.

[Switch]link-aggregation group 1 mode manual

# Configure GigabitEthernet 4/0/1 and GigabitEthernet 4/0/2 of the switch.

[Switch]interface gigabitethernet4/0/1

[Switch-GigabitEthernet4/0/1]port link-type trunk

[Switch-GigabitEthernet4/0/1]port trunk permit vlan 8 to 10

[Switch-GigabitEthernet4/0/1]port link-aggregation group 1

[Switch]interface ethernet4/0/2

[Switch-GigabitEthernet4/0/2]port link-type trunk

[Switch-GigabitEthernet4/0/2]port trunk permit vlan 8 to 10

[Switch-GigabitEthernet4/0/2]port link-aggregation group 1

2) Configure the access controller module.

<Switch>oap connect slot4

<AC>system-view

# Create VLAN 8 through VLAN 10.

[AC]vlan 8 to 10

# Configure GigabitEthernet 1/0/1 of the access controller module.

[AC]interface gigabitethernet 1/0/1

[AC-GigabitEthernet1/0/1]port link-type trunk

[AC-GigabitEthernet1/0/1]port trunk permit vlan 8 to 10

Configuring LSQM1WCMB0, LSBM1WCM2A0, or LSRM1WCM2A1

Network requirements

An access controller module LSQM1WCMB0, LSBM1WCM2A0 or LSRM1WCM2A1 is inserted in slot 4

of the switch. Packets on VLAN 1, and VLAN 8 through VLAN 10 are permitted to transfer between the

switch and the module. By default, packets on VLAN 1 are permitted to transfer between the module

and the switch.

H3C WX User Manual

Other manuals for H3C WX