H3C WX1800H Series - Irf Member Stack Enable

11
Predefined user roles
network-admin
Parameters
member-id: Specifies a member device by its IRF member ID. The following matrix shows the value
ranges for the member-id argument:
Hardware series Model Value range
WX1800H series
WX1804H
WX1810H
WX1820H
WX1840H
Not supported
WX3800H series
WX3820H
WX3840H
1 to 2
WX5800H series WX5860H 1 to 4
new-member-id: Assigns a new ID to the IRF member device. The following matrix shows the value
ranges for the new-member-id argument:
Hardware series Model Value range
WX1800H series
WX1804H
WX1810H
WX1820H
WX1840H
Not supported
WX3800H series
WX3820H
WX3840H
1 to 2
WX5800H series WX5860H 1 to 4
Usage guidelines
CAUTION:
An IRF member ID change can invalidate member ID-related settings, including interface and file
path settings, and cause data loss. Make sure you fully understand its impact on your live network.
Make sure each member device in the IRF fabric has a unique member ID.
The new IRF member ID, including the one set by using the undo irf member renumber command,
takes effect after you reboot the member device.
To cancel the change before you reboot the member device, use the undo irf member renumber
command. In the command, set the new member ID to be the same as the old member ID.
Examples
# Change the member ID of an IRF member device from 1 to 2.
<Sysname> system-view
[Sysname] irf member 1 renumber 2
Renumbering the member ID may result in configuration change or loss. Continue? [Y/N]:y
irf member stack enable
Use irf member stack enable to enable multimember stacking capability for an IRF member device.