14
irf-port
Use irf-port to access IRF port view.
Syntax
irf-port member-id
Views
System view
Predefined user roles
network-admin
Parameters
member-id: Specifies the IRF port on a device by the device's IRF member ID.
Usage guidelines
Each member device has only one IRF port.
You must enter IRF port view to bind links to the IRF port.
Examples
# Enter IRF port view of the IRF port on member device 1.
<Sysname> system-view
[Sysname] irf-port 1
Related commands
port group interface
irf-port-configuration active
Use irf-port-configuration active to activate IRF port settings.
Syntax
irf-port-configuration active
Views
System view
Predefined user roles
network-admin
Usage guidelines
After you bind links to an IRF port, you must execute this command for the bindings to take effect.
This command enables two devices to merge into one IRF fabric.
The system activates the IRF port settings automatically in the following situations:
• The configuration file that the device starts with contains IRF port bindings.
• You are binding links to an IRF port after an IRF fabric is formed.
Examples
To configure and activate IRF-port 1:
# Bind GigabitEthernet 1/0/1 to IRF-port 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
To Next Page
Loading...
