To Next Page

To Previous Page

Use the shutdown command to shut down a network interface before you bind it to or remove it from

an IRF port. To bring up the network interface after a binding or binding removal operation, use the

undo shutdown command.

The system does not dynamically remove IRF port bindings when IRF links are lost. To remove IRF

port bindings, you must use the undo port group interface command.

For more information about IRF port binding requirements, see IRF Configuration Guide.

Examples

# Bind GigabitEthernet 1/0/1 as a hybrid channel to IRF-port 2 on IRF member 2.

<Sysname> system-view

[Sysname] interface gigabitethernet 1/0/1

[Sysname-GigabitEthernet1/0/1] shutdown

[Sysname-GigabitEthernet1/0/1] quit

[Sysname] irf-port 2

[Sysname-irf-port2] port group interface gigabitethernet 1/0/1

[Sysname-irf-port2] quit

[Sysname] interface gigabitethernet 1/0/1

[Sysname-GigabitEthernet1/0/1] undo shutdown

Related commands

irf-port

Other manuals for H3C WX1800H Series

Questions and Answers:

Need help?

Do you have a question about the H3C WX1800H Series and is the answer not in the manual?

General