321
ALARMS
June 1999
96-8000
340 Cutter Comp Begin With G02 or G03 Select cutter compensation earlier. Cutter comp. must begin on
a linear move.
341 Cutter Comp End With G02 or G03 Disable cutter comp later.
342 Cutter Comp Path Too Small Geometry not possible. Check your geometry.
343 Display Queue Record Full Software error. Call your dealer.
344 Cutter Comp With G18 and G19 Cutter comp only allowed in XY plane (G17).
348 Motion Not Allowed In G93 Mode This alarm is generated if the mill is in Inverse Time Feed mode,
and a G12, G13, G70, G71, G72, G150, or any Group 9 motion
command is issued.
349 Prog Stop W/O Cancel Cutter Comp An X/Y cutter compensation exit move is required before a
program stop.
350 Cutter Comp Look Ahead Error There are too many non-movement blocks between motions
when cutter comp is being used. Remove some intervening
blocks.
351 Invalid P Code In a block with G103 (Block Lookahead Limit), a value between 0
and 15 must be used for the P code.
352 Aux Axis Power Off Aux C, U, V, or W axis indicate servo off. Check auxiliary axes.
Status from control was OFF.
353 Aux Axis No Home A ZERO RET has not been done yet on the aux axes. Check
auxiliary axes. Status from control was LOSS.
354 Aux Axis Aux axes not responding. Check auxiliary axes and RS-232
connections.
355 Aux Axis Position Mismatch between machine and aux axes position. Check aux
axes and Mismatch interfaces. Make sure no manual inputs
occur to aux axes.
356 Aux Axis Travel Limit Aux axes are attempting to travel past their limits.
357 Aux Axis Disabled Aux axes are disabled.
358 Multiple Aux Axis Can only move one auxiliary axis at a time.
359 Invalid I, J, or K In G12 or G13 Check your geometry.
360 Tool Changer Disabled Check Parameter 57. Not a normal condition for VF Series CNC
Mill.
361 Gear Change Disabled Check Parameter 57. Not a normal condition for VF Series CNC
Mill.
To Next Page
Loading...
