To Next PageTo Next Page
Need help?Do you have a question about the Haas UMC-750 and is the answer not in the manual?
General| Machine Category | Universal Machining Center |
|---|---|
| C Axis Travel | 360 degrees |
| Tool Capacity | 40+1 |
| Travels X Axis | 30 in (762 mm) |
| Travels Y Axis | 20 in (508 mm) |
| Travels Z Axis | 20 in (508 mm) |
| Spindle Speed | 8100 RPM |
| Spindle Motor | 30 hp (22.4 kW) vector drive |
| Spindle Taper | 40 |
| Control | Haas |
| Tool Changer Capacity | 40+1 |
Provides essential safety precautions and general guidelines for operating the Haas machine safely.
Details operational phases like setup, automatic mode, and material loading/unloading for Haas machines.
Crucial safety instructions and warnings that must be read and understood before operating the machine.
Lists the specified environmental conditions, including temperature and humidity, for safe machine operation.
Outlines acceptable noise levels and provides guidance on hearing protection measures.
Covers responsibilities and guidelines for safe operation of the machine without direct supervision.
Explains the machine's operational behavior and available functions when in setup mode.
Describes how machine functions are affected when doors are opened in different operating modes.
Warns against unauthorized modifications and their potential to void the machine's warranty.
Details risks and potential machine damage associated with the use of incorrect coolants.
Explains the purpose and significance of various safety decals found on the machine.
Provides detailed explanations for hazard, prohibited, and recommended action safety symbols.
Covers additional safety decals and general information pertinent to machine safety.
Directs users to online resources for supplementary safety information and best practices.
Provides a general introduction to the operator's manual supplement and its scope.
Illustrates and identifies the three primary operator zones within the UMC-750 machine.
Illustrates and defines the five axes of motion available on the UMC-750 and UMC-750SS models.
Lists the key technical specifications and dimensions for the UMC-750 machine.
Lists the key technical specifications and dimensions for the UMC-750P machine.
States that the coolant tank is an integrated component within the base of the UMC-750 machine.
Identifies the specific location of the coolant pumps and filters on the machine.
Provides a step-by-step procedure for safely cleaning and maintaining the coolant tank.
Introduces the standard Wireless Intuitive Probing System (WIPS) and its core functionalities.
Explains the Visual Programming System (VPS), including its relation to WIPS for machine probing.
Defines Machine Rotary Zero Point (MRZP) offsets for defining rotary table centers of rotation.
Details the procedure for verifying Machine Rotary Zero Point offsets using the VPS.
Explains the G234 TCPC software feature for accurate contouring in 4/5-axis programs.
Details the G254 DWO feature for 3+1/3+2 positioning, similar to TCPC functionality.
Procedure for adjusting and accurately recording the B-Axis work offset for machining alignment.
Procedure for adjusting and accurately recording the C-Axis work offset for machining alignment.
Manual procedure for setting the X, Y, and Z axis work offsets when WIPS is not used.
Procedure for setting X, Y, and Z axis work offsets utilizing the WIPS system.
Explains the Quick Rotary G28 feature for efficient return of rotary axes to their zero position.
Describes Setting 247 which controls simultaneous axis motion during tool changes.
Emphasizes the importance of regular maintenance for ensuring machine longevity and minimizing downtime.
Provides a detailed schedule of recommended maintenance tasks and their required intervals.
Directs users to online resources for updated maintenance procedures and additional information.
