Section 1 Specifications
Specifications are subject to change without notice.
Digital titrator
Specification Details
Enclosure Chemical- and impact-resistant acetal plastic
Weight 132 g (4.7 oz)
Delivery 800 digits/mL or 0.00125 mL/digit
Accuracy
1
± 1% for readings less than 100 digits
± 1% or less for readings more than 100 digits
Titration cartridges
Specification Details
Enclosure Disposable polypropylene or PVDF with PTFE-covered neoprene
seals and polyethylene resealable closures to cover the cartridge tip
Volume 13 mL
Concentration of titrant ± 0.5% concentration (typical) with normality and tolerances marked
on the label. The titrant concentrations are made for titrations of
10 to 40 turns (100 to 400 digits) of the delivery knob.
Number of tests 50 to 100. Most of the reagents supply 100 typical titrations. The
number of tests is dependant on the sample.
Weight 56.7 g (2 oz)
Section 2 General information
In no event will the manufacturer be liable for damages resulting from any
improper use of product or failure to comply with the instructions in the manual.
The manufacturer reserves the right to make changes in this manual and the
products it describes at any time, without notice or obligation. Revised editions
are found on the manufacturer’s website.
2.1 Safety information
The manufacturer is not responsible for any damages due to misapplication or
misuse of this product including, without limitation, direct, incidental and
consequential damages, and disclaims such damages to the full extent permitted
under applicable law. The user is solely responsible to identify critical application
1
Sampling, sample volume, dilution (if necessary), end point detection,
reagent quality and interferences have an affect on the accuracy.
English 3
To Next Page
Loading...
