Need help?Do you have a question about the Hach CL17sc and is the answer not in the manual?
General| Power Supply | 100-240 VAC, 50/60 Hz |
|---|---|
| Parameter | Free or Total Chlorine |
| Cycle Time | 2.5 minutes |
| Resolution | 0.01 mg/L |
| Measurement Method | Colorimetric |
| Measurement Range | 0 to 5 mg/L (ppm) Cl2 |
| Sample Temperature Range | 5 to 40 °C |
| Output | 4-20 mA |
| Enclosure Rating | IP66 |
| Operating Humidity | 5 - 95% non-condensing |
| Sample Flow Rate | 200 to 400 mL/min |
| Wetted Materials | PVC, Glass, Silicone |
| Relays | Two SPDT relays |
| Reagent Consumption | Approximately 1 liter per 31 days |
Steps for mounting the analyzer and connecting plumbing.
Connecting the analyzer to the controller.
Initial setup and priming of the analyzer.
Adjusting the sample flow rate.
Settings for analyzer name, measurement type, and alarms.
Explains error messages and solutions when the status light is red.
Explains warning messages and solutions when the status light is yellow.
To Next Page
