How to fix high readings on Hach CA610?
To address high readings, check the fluoride and reference electrodes for looseness, looking for the O-ring and tightening the electrode if needed. Ensure the electrode was conditioned prior to use by allowing overnight operation and recalibrating. Also, inspect the fluoride electrode for low or missing inner fill solution and refill if necessary.
What to do if Hach Measuring Instruments shows low readings?
If the Hach Measuring Instruments shows low readings, first, ensure the pressure plate screws are tightened. Next, adjust the sample flow and inspect the sample filter, replacing it if blocked. After that, refer to the plumbing diagram to correctly plumb the reagent and sample lines. Finally, check the drain line for blockages; if no flow is seen, remove the drain line and check for any obstructions.
Why Hach Measuring Instruments gives erratic readings?
If the Hach Measuring Instruments is giving erratic readings, ensure the fluoride electrode is installed in the top position and the reference electrode is in the bottom position. If the analyzer is new, flush the system with surfactant (2697453) in place of the sample to ensure parts are sufficiently wetted. Also, refill the measuring electrode inner fill solution if there is excess air in the inner fill solution chamber.
Why Hach CA610 Measuring Instruments display is on but the pump motor won't operate?
If the display comes on but the pump motor will not operate, there might be several reasons. First, ensure that the line voltage is within specification. Next, set the line voltage selector switch to the correct voltage. Then, connect the motor cable. If these steps do not solve the issue, the motor may be defective, and you should call Technical Service.
Covers general safety procedures and warnings for operating the instrument.
Explains different hazard levels like Danger, Warning, and Caution used in the manual.
Brief description of the CA610 Fluoride Analyzer's function and measurement range.
Guidelines for properly mounting the analyzer on an indoor wall.
Steps and diagrams for connecting sample, drain, and reagent lines correctly.
Detailed steps for connecting the instrument to its power source safely.
Procedure for assembling and installing the reference and measuring electrodes.
Step-by-step guide for installing the TISAB buffer and fluoride standards.
Detailed instructions for performing self-calibration and setting calibration parameters.
Instructions for safely replacing the TISAB and standard reagent bottles.
Procedures for refilling electrode solution or replacing the lanthanum crystal tip.
General| Resolution | 0.01 mg/L |
|---|---|
| Power Supply | 100-240 V AC, 50/60 Hz |
| Display | LCD |
| Sample Temperature | 5 - 40 °C (41 - 104 °F) |
| Measurement Method | Colorimetric |
To Next Page
