Figure 11 CA610 keypad and display
Table 4 Keypad description
Key Function Description
1 UP, DOWN, RIGHT and LEFT ARROW
keys
Use to navigate the menu or edit values
2 MENU Goes to the Alarm, Recorder, Maintenance and Setup menus.
3 Screen Shows measurement and menu information
4 Alarm LED Shows that alarms are active
5 ENTER Confirms an edited value; menu navigation
6 EXIT Erases an edited value; menu navigation
Section 5 Startup
5.1 Install the reagents
W A R N I N G
Chemical exposure hazard. Obey laboratory safety procedures and wear all of the personal protective
equipment appropriate to the chemicals that are handled. Refer to the current safety data sheets
(MSDS/SDS) for safety protocols.
The analyzer uses three reagents: a total ionic strength adjustment (TISAB) buffer solution and two
fluoride standards. The solutions are formulated at the factory and ready to install.
1. Remove the cap from the bottle.
2. Insert the cap/tubing assembly into the appropriate bottle.
Note: See the label on the cap/tubing assembly.
English
17
To Next Page
Loading...
