Need help?Do you have a question about the Hach 1720E and is the answer not in the manual?
General| Resolution | 0.001 NTU |
|---|---|
| Sample Temperature | 0 - 50 °C (32 - 122 °F) |
| Operating Temperature | 0 - 50 °C (32 - 122 °F) |
| Detector | Silicon photodiode |
| Weight | 4.5 kg (10 lbs) |
| Measurement Principle | Nephelometric |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Output | 4-20 mA |
| Light Source | LED |
| Enclosure Rating | NEMA 4X (IP66) |
Details accuracy specifications for the turbidimeter.
Details linearity specifications for the turbidimeter.
Details repeatability specifications for the turbidimeter.
Provides response time data based on flow rate.
Specifies the required sample flow rate for operation.
Specifies the acceptable storage temperature range.
Specifies the acceptable operating temperature range.
Specifies the acceptable sample temperature range.
Specifies the acceptable operating humidity range.
Details the power requirements for the instrument.
Describes the type of sample inlet fitting used.
Lists available signal averaging time options.
Provides the physical dimensions of the turbidimeter.
Specifies available sensor cable lengths.
Lists available mounting options for the instrument.
Details the shipping weight of the product.
Outlines the available calibration methods.
Describes the wet verification method.
Describes the dry verification method.
Lists recommended maintenance tasks.
Details the suitable installation environment.
Specifies the primary compliance method used.
States the limit of detection for the instrument.
Provides crucial safety information for the user.
Explains the fundamental working principle of the turbidimeter.
Instructions for connecting the sensor to the controller.
Detailed steps for hard-wiring the sensor.
Instructions for connecting the sensor to the sc1000 controller.
General guidance for installing the turbidimeter body.
Steps for securely mounting the turbidimeter body.
Procedure for correctly installing the sensor head assembly.
Steps for properly installing the sample line.
Details on making sample inlet and drain connections.
Overview of initial system operation and setup.
Guidance on initiating sample flow and stabilization.
Instructions for configuring sensor settings and naming.
Details on configuring and managing data logging.
Information on accessing diagnostic error and warning lists.
Explains the various options within the sensor setup menu.
Overview of calibration and verification procedures.
Step-by-step guide for user-prepared calibration.
Instructions for calibrating using StablCal standards.
Methods for verifying instrument performance.
Procedure for performing dry instrument verification.
Procedure for performing wet instrument verification.
How to access and interpret calibration/verification logs.
Explanation of the clean water offset feature.
Steps to enter and adjust the offset value.
Outlines routine maintenance tasks and frequency.
Procedure for safely removing a sensor.
Steps for reinstalling a sensor after maintenance.
Detailed instructions for cleaning instrument components.
Specific steps for cleaning the photocell window.
Guide to cleaning the body and bubble trap.
Procedure for replacing the lamp assembly.
Lists and defines error codes displayed by the sensor.
Lists and defines warning codes displayed by the sensor.
Provides common issues, causes, and corrective actions.
Lists malfunctions not captured in the event log.
Explains event codes and their meanings.
Lists essential replacement parts for the instrument.
Lists available optional accessories for the turbidimeter.
Details standards and accessories for calibration.
Information regarding product safety standards and certifications.
Details EMC immunity standards the equipment complies with.
Information on radio frequency emissions compliance.
Compliance details for Canadian regulations.
FCC compliance details for Class A digital devices.
Lists Modbus registers for sensor data.
To Next Page
