Specification Details
Resolution 0.01 to 999.99
Sludge compensation Yes
Measuring interval 15, 30 seconds, 1, 5, 10, 30 minutes
Units mg/L, ppm
T100 response time 1 minute
Signal average 1 to 12 measurements
Power consumption 9 W
Cable length 10 m (33 ft)
Extension cables are available: 5, 10, 15, 20, 30 and 50 m. The maximum cable
length is 60 m (190 ft).
Environmental rating IP 68
Sensor pressure limit 0.5 bar (7.3 psi)
Ambient temperature 2 °C to 40 °C (36 °F to 100 °F), 95% relative humidity, non-condensing
Sample temperature 2 °C to 40 °C (36 °F to 100 °F), 95% relative humidity, non-condensing
Dimensions (Ø x L) 70 × 470 mm (3 × 18.5 inches) approximately
Weight 4.8 kg (10.6 lb) with 10 m cable
Altitude 2000 m (6562 ft) maximum
Pollution degree 2
Overvoltage category III
Environmental conditions Outdoor use
Sensor materials Enclosure: Stainless steel
Enclosure seals: Silicone
Wiper shaft, arm (5 mm) and wiper blade carrier (1 mm and 2 mm): Stainless steel
Wiper blade: Silicone
Measuring window: Quartz glass
Sensor cable: Polyurethane (PUR)
Cable gland: Stainless steel
Seal cable gland: Silicone HT
Process connection Immersion directly in media
Bypass with flow through unit
Sedimenter
Certifications CE, CMIM and UKCA approved, FCC, ISED
Warranty 1 year (EU: 2 years)
Section 2 General information
In no event will the manufacturer be liable for damages resulting from any improper use of product or
failure to comply with the instructions in the manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer’s website.
4
English
To Next Page
Loading...