Page 11
The following events are defined:
Maintenance and Troubleshooting (cont)
Type Name Description
Information
Measure Normal measurement mode.
Filter enabled The gas measurements are filtered.
Sample measurement The sample measurement is started.
Meas. not ready The measurement is not ready (e.g. at startup)
Autotest in progress The autotest is running.
Autotest failed The autotest has failed.
Alarm snooze The alarm snooze is ON.
Warning
Calibration Channel in calibration.
Hold The measurement is frozen.
Alarm low low The gas concentration is below the Alarm LowLow limit.
Alarm low The gas concentration is below the Alarm Low limit.
Alarm high The gas concentration is above the Alarm High limit.
Alarm high high The gas concentration is above the Alarm HighHigh limit.
Calibration required The calibration of the sensor is required.
Service required The sensor requires a service.
Alarm
Channel disabled The channel has been disabled.
Channel out
The measurement board has been disconnected (or
does not answer).
Sensor out The sensor has been disconnected.
PROFIBUS-DP value not
updated
The PROFIBUS-DP module has not received
measurements from the instrument for 30 seconds.
To Next Page
Loading...
