Need help?Do you have a question about the Hach Polymetron 9610sc SiO2 and is the answer not in the manual?
General| Brand | Hach |
|---|---|
| Model | Polymetron 9610sc SiO2 |
| Category | Measuring Instruments |
| Language | English |
Explains the meaning of hazard symbols and terms like DANGER, WARNING, CAUTION, NOTICE.
Details safety alert symbols and their meanings for potential hazards.
Details compliance with Canadian regulations for digital apparatus.
Explains the device's compliance with FCC rules for digital devices.
Details plumbing connections and requirements, including access ports and tubing.
Covers wall mounting safety and requirements for the equipment.
Instructions for removing rubber plugs and knockouts from electrical access ports.
Overview of possible wiring connections and required wire gauge.
Instructions and recommendations for connecting power and cords safely.
How to connect relays, 4-20mA outputs, digital inputs, and optional devices.
Information on adding modules for extra functionality.
Steps for installing analyzer bottles, including identifying and capping them correctly.
Procedure for installing the stir bar in the colorimeter sample cell.
Describes the function of each key on the analyzer's keypad.
Refers to figures for descriptions of measurement and system status screens.
Explains the meaning of service and measurement quality indicator bars.
Details how to access and navigate different display modes like graphical display.
Provides instructions and ingredients for preparing reagent solutions.
Step-by-step guide to prepare a specific silica standard solution.
Instructions on how to power on the analyzer.
Guide for initial configuration after powering on the analyzer for the first time.
Steps to start/stop measurements and set the order for multi-channel analyzers.
Options to analyze external samples or extract samples for external analysis.
Procedure for measuring external samples or standards using the grab sample funnel.
How to manually dispense a grab sample from the analyzer for external analysis.
Details how to change configuration settings via SETUP SYSTEM menu.
How to set variables, parameters, units, and formulas for analyzer calculations.
Steps to configure 4-20mA outputs and relay setups.
Details options for linear control and PID control for 4-20mA outputs.
How to configure relay activation options like ALARM, FEEDER CONTROL, EVENT CONTROL.
How to configure the analyzer to hold outputs or transfer them when communications are lost.
How to view software and serial numbers for the analyzer and connected modules.
How to use an SD card for software updates and data logging.
Steps to update the analyzer's firmware using an SD card.
How to activate and schedule automatic calibration cycles.
Procedure to initiate a manual calibration of the analyzer.
Recommended schedule of maintenance tasks for the analyzer.
How to view service history, part information, and upcoming service dates.
Procedures for safely shutting down and restarting the analyzer for maintenance.
Steps for cleaning the instrument exterior, spills, and sample lines/valves.
Procedure for cleaning the sample cell in the colorimeter, requiring shutdown mode.
How to clean the grab sample funnel before and after each use.
Steps to update the analyzer's firmware using an SD card.
Explains how display background and status lights indicate errors, warnings, or reminders.
How to access help screens for error definitions and correction tasks.
How to examine, hold, and simulate 4-20 mA and relay outputs.
How to acknowledge error messages or view help screens.
To Next Page