Need help?Do you have a question about the Haemonetics PCS2 and is the answer not in the manual?
General| Model | PCS2 |
|---|---|
| Manufacturer | Haemonetics |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Portability | Mobile unit with wheels |
| Operating Modes | Automated |
| Regulatory Compliance | Complies with relevant medical device regulations (e.g., FDA) |
| Operating Temperature | 15°C to 30°C (59°F to 86°F) |
Describes the purpose and scope of the service manual for the PCS2.
Provides contact information for Haemonetics Product Support and troubleshooting assistance.
Covers cautions, static discharge, and general notes for safe operation during part replacement.
Details the removal and installation procedures for rear, front panels, and cuff connectors.
Instructions for replacing donor line air detectors and line sensors.
Covers replacement of front panel distribution board, card cage, and distribution cards.
Covers replacement of centrifuge cover halves, fluid sensor, and bowl optics.
Instructions for replacing Todd and Condor power supply assemblies.
Outlines visual checks for machine integrity and component status.
Covers electrical, pneumatic, and hardware inspections for system integrity.
Details power supply voltage tests and other calibration verification checks.
Includes tests for Valves, Weigher, DPM Sensor, Cuff, Display, and Keyboard.
Covers fluid sensor, centrifuge, donor lights, line sensor, and bowl optics tests.
Details leakage current and ground continuity tests for safety compliance.
Procedures for calibrating Todd and Condor power supply voltages.
Steps to calibrate the bowl optics signal for accurate readings.
Covers calibration of the line sensor and Analog-to-Digital converters.
Details calibration procedures for the weigher and Donor Pressure Monitor.
Explains calibration for centrifuge speed and safety system parameters.
Covers cosmetic and internal workmanship checks before configuration.
Guides through language, protocol selection, and machine settings.
Details setting serial numbers and collection weights for the PCS2.
Includes tests for valves, weigher, sensors, centrifuge, and air detectors.
Explains status, CPU, and safety system error messages.
Lists CPU error codes, descriptions, and suggested resolutions.
Details safety system fault detection and error registers.
Visual identification of major PCS2 assemblies and parts.
Lists specific part numbers for various assemblies and components.
Recommended cleaning frequency for PCS2 components.
Detailed steps for cleaning various parts like panels, sensors, and pumps.
Procedures for performing leakage current checks and Return Goods Authorization.
To Next Page
