Haier AB18CS1ERA - Page 100

98
Super Match
Wiring diagram
AC28ES1ERA(S) AC36ES1ERA(S) AC48FS1ERA(S) AC60FS1ERA(S)
WARNING
CAUTION
CAUTION
■ The power cable and connecting cable are self-provided.
■ Always use a special branch circuit and install a special receptacle to supply power to the room air conditioner.
■ Use a circuit breaker and receptacle matched to the capacity of the room air conditioner.
■ The circuit breaker is installed in the permanent wiring. Always use a circuit that can trip all the poles of the wiring
and has an isolation distance of at least 3mm between the contacts of each pole.
■ Perform wiring work in accordance with standards so that the room air conditioner can be operated safely and
positively.
■ Install a leakage circuit breaker in accordance with the related laws and regulations and electric company
standards.
■ The power source capacity must be the sum of the room air conditioner current and the current of other electrical
appliances. When the current contracted capacity is insufcient, change the contracted capacity.
■ When the voltage is low and the air conditioner is difcult to start, contact the power company the voltage raised.
FRESH AIR INTAKE
1. Open up the knockout hole for the fresh air intake. If using half-concealed
installation, open up the top knockout hole instead.
■ When removing the cabinet (iron plate), be careful not to damage the indoor
unit internal parts and surrounding area (outer case).
■ When processing the cabinet (iron plate), be careful not to injury yourself with
burrs,etc.
2. Fasten the round ange (optional) to the fresh air intake. If using half- concealed
installation, attach to the top.
3. Connect the duct to the round ange.
4. Seal with a band and vinyl tape,etc. so that air does not leak from the connection.