Heating Mode
Note: For cooling only type, this function is invalid.
Press ON/OFF button
Unit stops running, and when entering this mode for the
next time, it will show the previous setting.
4
Note:
In this mode, temp. can't be selected, temp.setting will not be
shown in LCD display.In Fan operation mode, "AUTO" fan
speed is not available. Operation cycles are as follows:
LOW MID HIGH
ON
OFF
TEMP
HEALTH
FAN
MODE
SLEEP
SWING
CLOCK
TIMER
SET
LOCKLIGHT
RESET
1
2
3
HEAT
4
5
3
Press ON/OFF button
Unit starts running.
The previous status appears on the display
(except. TIMER, SLEEP mode)
Press MODE button. For each press,operation mode
changes as follows:
Select Heating operation " " appears and Heating
operation starts.
Press FAN button. For each press, fan speed changes as
follows:
4
1
2
3
Select temp. button
Press TEMP button
Every time the button is pressed, temp. setting increases 1 C
Every time the button is pressed, temp. setting decreases 1 C
If the button is kept pressed, setting will increase or
decrease quickly.
Press ON/OFF button
5
Unit stops running, and when entering this mode for the next
time, it will show the previous setting.
In heat mode,warm air will blow out after a short period of
time due to cold-draft prevention function.
LOW MID HIGH AUTO
AUTO COOL DRY FAN HEAT
>a__WcU[S^ <[c >a`V[e[a`Wc
-100-
To Next Page
Loading...
