Please connect the connecting pipes between indoor and outdoor unit according to the following method.
a) When introducing the pipe from right side
Use attached accessory <A> to connect the on-the-spot connecting pipe and gas pipe.
B
A
A B
2
Use attached accessory <A> to connect the on-the-spot connecting pipe and gas pipe.
b) When introducing pipe from rear side or left side
After finishing connection of connecting pipe, please do thermal insulation treatment by
using the attached thermal insulation material. Otherwise, it may cause water leakage.
Setting of wire controller dial switch
Setting of this series of air conditioner dial switch: 1, ON; 2, ON.
3
L1
L2
L3
N
Power supply:
3N,380-400V,50Hz
1
2
3
Terminal block of
indoor unit
1
2
3
Terminal block of
outdoor unit
Power terminal
block of outdoor
unit
Y/G
Wiring diagram between I.U.&O.U.
AP88NACBEA/AU88NATBEA
>a__WcU[S^ <[c >a`V[e[a`Wc
-181-
To Next Page
Loading...
