To cancel TIMER mode
Just press TIMER button several times until TIMER mode disappears.
(6) Time confirming for TIMER OFF
After time setting, press SET button to confirm, " " stops flashing.
Time displayed: Unit start or stop at x hour x min
OFF
According to the Time setting sequence of TIMER ON or TIMER OFF,either ON-OFF or OFF-ON can be
achieved.
After turning on the unit and set the desired working mode. Press the Health
button, the LCD will display " ", the unit begins health operation (start the
negative ion generation device). Press the Health button again, the " "
displayed on the LCD disappears, health operation is cancelled (turn off the
negative ion generation device).
Note: When indoor fan motor does not work, the unit will automatically turn
off negative ion generation device.
Health operation
After the start of Health operation, the negative ion generator will generate
large amount of negative ion, which can effectively balance the amount of
positive & negative ion in the air and has the bacteria-killing and accelerating
the dust deposition of the room to make the room air fresh and healthy.
About Health operation
1
Health
& Fresh Air operation
Auto restart function
TEMP
FAN
ON
OFF
HEALTH
MODE
SLEEP
SWING
CLOCK
SET
TIMER
HEAT
RESET
LIGHT
LOCK
Setting method (to be applied for a necessary situation) :
Setting Method: When the remote controller is on (excluding timer mode and fan mode), press the "SLEEP"
button on the remote controller 10 times within 5 seconds, and after the buzzer rings 4 times, the air conditioner
will enter the state of auto restart.
Cancel Method: Press the "SLEEP" button on the remote controller 10 times within 5 seconds, and after
the buzzer rings 2 timer, the auto restart mode will be cancelled.
Notes: When a power failure suddenly occurs during the air conditioner is working after the power failure
compensation is set, if the air conditioner will not be used for a long time, please cut off the power supply to
prevent its operation from being resumed after the power is supplied again, or press
the "Switch On/Off" button after the power comes again.
After the power failure compensation is set, if power failure suddenly occurs while the air conditioner is working,
it will resume the previous working state when the power is supplied again.
If the unit has not the "SLEEP" button or function, please realize the function by pressing "SWING" with
the same method.
>a__WcU[S^ <[c >a`V[e[a`Wc
-104-
To Next Page
Loading...
