Haier AU182AFBJA - Fan Operation

Press FAN button. For each press, fan speed changes as follows:
Press ON/OFF button
Unit stops running, and when
entering this mode for the next
time, it will show the previous setting
Unit runs at the speed displayed on LCD.
In DRY mode, when room temp.becomes 2 C lower than temp. setting,unit will run
intermittently at LOW speed regardless of FAN setting.
4
5
Fan operation
Press ON/OFF button
Unit starts running.
The previous status appears on the display
(except. TIMER, SLEEP mode)
Press MODE button. For each press,operation mode
changes as follows:
Select Fan operation shows " ", Fan operation starts.
Press ON/OFF button
Unit stops running, and when entering this mode for the next time, it will
show the previous setting.
4
1
2
3
Press FAN button. For each press, fan speed changes as follows:
Note:
In this mode, temp. can't be selected, temp.setting will not be
shown in LCD display.In Fan operation mode, "AUTO" fan
speed is not available. Operation cycles are as follows:
LOW MID HIGH
LOW MID HIGH AUTO
Unit runs at the speed displayed on LCD.
Remote
controller
AUTO COOL DRY FAN HEAT
ON
OFF
TEMP
HEALTH
FAN
MODE
SLEEP
SWING
CLOCK
TIMER
SET
LOCKLIGHT
RESET
1
2
3
HEAT
POWER/SOFT
5
3
4
Ultra-low air flow
Temp.setting+2 C
Temp.setting
On reaching 2 C lower than temp.
setting,unitwill run in mild DRY mode.
COOL operation starts when room
temp. is higher than temp. setting.
ON
OFF
TEMP
HEALTH
FAN
MODE
SLEEP
SWING
CLOCK
TIMER
SET
LOCKLIGHT
RESET
1
2
HEAT
POWER/SOFT
3
4
LOW MID HIGH
>a__WcU[S^ <[c >a`V[e[a`Wc
-92-