Haier AU182AFBJA - Standard Accessories

Parts in the following list are accessories for the
unit installation which can be used if necessary.
Standard accessories
1. Screw driver 2. Hacksaw
3. 70mm dia. hole core drill 4. Spanner (dia. 17, 27mm)
5. Spanner (14, 17, 27mm) 6. Pipe cutter
7. Flaring tool 8. Knife
9. Nipper 10. Gas leakage detector or soap water
11. Measuring tape 12. Reamer
13. Refrigerant oil 14. Lead-solder tool
Following parts shall be field supplied
Installation procedure
Installation instruction
Notice
Warning
This manual can not include all kinds of conditions, if you have new requirements and questions, please
contact with local Haier Sales Center.
Before installing the unit, please read this manual carefully. Improper installation may cause accidents
and make unit damage or death.
Installation tools
L-shaped metal
Fall-prevention fitting metal
Self-tapping scerw
Wall hole cover
Piping hole cover
No. QTY
Shape and description
Wooden bolt
1
5
1
2
3
4
5
6
2
2
1
2
Mark
Parts name
Adhesive tape
Pipe clip
Connecting hose
Insulation material
Putty
Drain hose
A
B
C
D
E
F
1. Before installation
[Before finishing installation, do not throw the attached installation parts away.]
7.10 Cabinet indoor unit(88)
Confirm the route to carry the units to the installation place.
Do not remove the package of the unit, before carrying it to the installation place.
When have to remove the package, use a soft material or protection board with rope to lift
the unit to prevent the unit from damage or bumping scrape.
>a__WcU[S^ <[c >a`V[e[a`Wc
-177-