EasyManua.ls Logo

Haier HD90-A636-E - Loading and Removing Laundry

Haier HD90-A636-E
340 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Daily use
EN
18
Tips:
Separate white clothes from coloured ones.
Unfold large items such as bed sheets, table cloths, etc.
Bed linen and pillowcases should be button, so that small parts cannot collect inside.
Close zippers and hooks, and tie loose belts without metal parts, apron strings etc.
together.
Place small items such as socks, belts, bras, etc. in a wash bag.
Make sure all buttons are sewn on tightly .
Sew or remove loose metal parts of garments, such as e.g. metal buttons, bow of
bras before inserting. Otherwise such parts can cause noise and damage the drum.
Do not over-dry easy-care linen. Risk of the crease. Allow fi nal drying at the air.
Knitwear (e.g. T-shirts, underwear) sometimes run up during drying. Only use dry level
READY to IRON
and drag in the form afterwards.
For pre-dried, multi-layered garments or for nal drying the time-programme
(TIMER
) should be chosen.
Loading the appliance
Loosen up and insert presorted laundry.
Don‘t overload.
Close the door carefully. Make sure that no pieces of laundry are pinched.
Removing and adding laundry
WARNING!
Never turn the dryer off before the end of the drying cycle unless all items are quickly
removed and spread out that the heat can be released.
To remove or add laundry the programme can be interrupted at any time:
Open the door. The cycle interrupts.
Be careful when removing or adding the laundry! The Interior of the drum or the laun-
dry itself may be hot, so that there is danger of burns .
To continue the programme, press the “Start/Pause” button
after closing the door.

Table of Contents

Related product manuals