10
Order No. TL1001S003V0
Rev.
Service Manual
Issue
DELAY START BUTTON
Ţ
Press this button to delay the start of your wash cycle between 1 - 24 hours
in one hour increments.
Ţ
Use this button to select a delayed start of the washer. The number of hours
will be shown in the Estimated Time Remaining Display. Each press of the
Delay Start Button will increase the time by 1 hour.
Ţ
One button press after 24 will cancel the Delay Start feature. You can also
POWER Button.
Ţ
The START/PAUSE Button must be selected to begin the countdown.
ESTIMATED TIME REMAINING DISPLAY
Ţ
The Estimated Time Remaining Display shows the estimated cycle time in
minutes.
Ţ
When the Delay Start option is being used, the Estimated Time Remaining
Display will show the delay time in hours.
START/PAUSE BUTTON
Ţ
Press this button to start a selected cycle or to pause an operating cycle.
NOTE: After starting the wash cycle, you must pause the operating cycle to
change the Water Level setting.
POWER BUTTON
Ţ
Press the POWER button to turn on the washer.
NOTE: If the washer is turned on, but START/PAUSE is not pressed, the power
To Next Page
Loading...
