8
Control panel - function buttons
6a-“Function“ (button a)
Touch it to select sequentially required functions and settings.
The related symbol will flash.
- : temperature function
--°C = cold/15/20/30/40/60/90
- : spin speed function
0/400/600/800/1000/1200/1400 rpm
- : extras rinse function adds 1-2 rinse cycles. Preferable
to better flush out possible residues.
6b-“Selection“ (button b)
Touch it to select heating temperature, spin, speed or extra
rinse times acording to the curret chosen function, the related
symbol is blinking. Function will be activated after „Start/Pause“
button is touched.
6c-“Delay“ – End time delay (button c)
Touch it to light up related symbol and display present pro-
gramme end time. Accordingly to all programme settings start
of wash cycle will be delayed.
End time delay could be increased by turning propgramme se-
lector in steps of 30 minutes from 0,5-24h. For example display
off „6:30“ means end of programm cycle will be in 6 hours
and 30 minutes. Function will be activated after „Start/Pause“
button is touched.
It is not applicable to programme „Spin/Drain“ and „Self Clean“.
Note: End time must always be longer than programme cycle
time. Otherwise operation will start immediately, although
chosen end time could not be reached.
“Child lock“ - control panel lock function
(button a + c)
This option blocks all panel elements against activation. After
starting a programme press simultaneously “Function“+“Delay“
for about 3 seconds. Panel lock symbol is now displayed. Next
repetition deblocks any function. For unlocking please press
again the two buttons
To get best results in each programme Haier has well defined specific default settings.
If there is no special requirement default settings are recommended. Accordingly to
these factory settings many programme parameters and additional functions could be
individually changed (see “programmes“ and “function“ buttons).
Function Selection
Delay
To Next Page
Loading...
Need help?
General