Why won't my Haier Washer start?
Your Haier Washer might not start because the program hasn't been initiated yet, the door isn't properly closed, the machine hasn't been switched on, there's a power failure, or the child lock is activated. Ensure the program is correctly set and started, the door is securely closed, the machine is switched on, the power supply is working, and the child lock is deactivated.
How to stop my Haier HW90-B14939 from vibrating so much during spinning?
Excessive vibration during spinning could be due to transportation bolts not being removed, the appliance not having a solid position, or an incorrect machine load. Remove all transportation bolts, ensure the washer is on solid, level ground, and check that the load weight and balance are correct.
What to do if my Haier Washer is not getting water?
If your Haier Washer isn't getting water, check the water tap to ensure it's open. Also, inspect the inlet hose for any kinks, verify that the water pressure is at least 0.03 MPa, make sure the door is properly closed and ensure a stable water supply.
How to fix the Unb error on my Haier Washer?
The 'Unb' error indicates an unbalanced load. To resolve this, check and balance the laundry load in the drum and reduce the load size if necessary.
Why is my Haier HW90-B14939 showing a drainage failure?
A drainage failure can occur if the drain hose is blocked or if the drain hose end is higher than 100 cm above the floor level. Unblock the drain hose and ensure it is properly installed.
What does CLR FLTR mean on my Haier HW90-B14939?
The 'CLR FLTR' error indicates a drainage error, meaning water is not fully drained within 6 minutes. Check the drain hose installation.
Why is my Haier HW90-B14939 constantly draining?
Your Haier Washer might be constantly draining if the height of the drain hose is below 80 cm or if the drain hose end is reaching into water. Make sure that the drain hose is properly installed and is not in water.
What to do if my Haier Washer stops mid-cycle?
If your Haier Washer stops before completing the wash cycle, check both the power and water supply to ensure there are no interruptions.
Why is my Haier HW90-B14939 not cleaning clothes properly?
If your Haier Washer isn't cleaning clothes properly, the selected program might not match the degree of pollution, the detergent quantity might be insufficient, the maximum load might have been exceeded, or the laundry might be unevenly distributed in the drum. Try selecting another program, use the appropriate amount of detergent according to the degree of pollution and manufacturer specifications, reduce the load size, and ensure the laundry is loosely distributed.
Why is there excessive foam in my Haier HW90-B14939 Washer detergent drawer?
Excessive foam in the detergent drawer can occur if the detergent used is not appropriate or if too much detergent is being used. Check detergent recommendations and reduce the amount of detergent used.
Important safety advice before operating the appliance.
Safety guidelines for operating the appliance during normal use.
Visual identification of the front and rear of the washing machine.
How to select washing programmes using the knob.
Details what information is shown on the appliance display.
Steps and advice for sorting and preparing clothes for washing.
Solutions for problems indicated by specific display error codes.
General| Door color | Black |
|---|---|
| Door hinge | Left |
| Drum volume | 54 L |
| Control type | Buttons, Rotary |
| Door opening | Side opening |
| Loading type | Front-load |
| Drum material | Stainless steel |
| Product color | White |
| Built-in display | Yes |
| Appliance placement | Freestanding |
| Drum capacity | 9 kg |
| Cycle time (max) | 228 min |
| Delay start (max) | 24 h |
| Spin-drying class | B |
| Maximum spin speed | 1400 RPM |
| Noise level (spin) | 67 dB |
| Noise level (wash) | - dB |
| Foam control system | - |
| Number of washing programs | 15 |
| Cycle time (quick washing program) | 15 min |
| Power plug type | Type F |
| AC input voltage | 220 - 240 V |
| Energy efficiency scale | A to G |
| Water consumption per cycle | 47 L |
| Energy consumption washing per cycle | 0.48 kWh |
| Package depth | 695 mm |
| Package width | 653 mm |
| Package height | 890 mm |
| Package weight | 77000 g |
Weight and Dimensions| Depth | 670 mm |
|---|---|
| Width | 600 mm |
| Height | 850 mm |
| Weight | 74000 g |
To Next Page