Why won't my Haier HW90-B14CIN start?
Your Haier Washer might not start due to several reasons. Ensure that the programme is properly set and started, the door is completely closed, and the machine is switched on. Also, check the power supply and deactivate the child lock if it's enabled.
How to stop my Haier HW90-B14CIN from vibrating so much during spinning?
Excessive vibration in your Haier Washer during spinning can be due to a few reasons. Make sure all transportation bolts have been removed from the appliance. Ensure the appliance is on solid, level ground. Also, check that the machine load is correctly balanced and not overweight.
How do I fix a drainage failure in my Haier Washer?
A drainage failure in your Haier Washer may occur if the drain hose is blocked or improperly installed. Ensure that the drain hose is correctly installed and not higher than 100 cm.
Why does my Haier HW90-B14CIN Washer show CLR FLTR?
The CLR FLTR error on your Haier Washer indicates a drainage error. Check the drain hose installation.
What to do if my Haier Washer is draining improperly?
If your Haier Washer is draining improperly, it might be because the drain hose is not correctly positioned. Ensure the drain hose is properly installed and that its height is at least 80 cm. Also, make sure the drain hose end is not submerged in water.
Why does my Haier HW90-B14CIN Washer stop mid-cycle?
If your Haier Washer stops before completing the wash cycle, it could be due to a water or electric failure. Check both the power and water supply to ensure they are functioning correctly.
What to do if spinning fails in my Haier Washer?
If spinning fails in your Haier Washer, check the machine load and laundry. Then, run a spinning programme again.
What does CLR FLTR mean on my Haier Washer?
CLR FLTR on your Haier Washer indicates a drainage error. Check the drain hose installation.
What to do if my Haier HW90-B14CIN Washer shows error E4?
If your Haier Washer displays error code E4, it indicates that the water level has not been reached or the drain hose is self-syphoning. Ensure the tap is fully opened and the water pressure is normal. Also, check the drain hose installation.
How to fix E2 error on Haier HW90-B14CIN Washer?
The E2 error on your Haier Washer means there's a lock error. Ensure you shut the door properly.
General| Model | HW90-B14CIN |
|---|---|
| Loading type | Front load |
| Capacity | 9 kg |
| Maximum spin speed | 1400 RPM |
| Spin Speed | 1400 RPM |
| Energy efficiency class | A |
| Energy Rating | A |
| Noise level spinning | 76 dB |
| Dimensions (H x W x D) | 850 x 600 x 600 mm |
| Weight | 72 kg |
| Color | White |
| Type | Automatic |
| Programs | 15 |
To Next Page