Haier MRV5 - Installation Place Selection

4
Installation instruction
(2) Installation place selection
Air-conditioner can't be
installed in the place with
inammable gas. Or it will
cause re hazard.
The unit should be installed
at the place with good
ventilation. No obstacle at
the air inlet/outlet. And no
strong wind blows the unit.
The installation space refers
to the latter info.
The unit should be installed at
the strong enough place. Or it will
cause vibration and noise.
• The unit is better not be
installed at the below places, or
it will cause damage.
• The place where there is
corrosive gas (spa area etc).
• The place blowing salty air
(seaside etc).
• Exsits the strong coal smoke.
• The place with high humidity.
• The place where there is device
emitting Hertzian waves.
• The place where voltage
changes greatly.
• The place where the water
can ow uently.
• The place where no other
heat source will a󰀨ect the
unit.
• Pay attention to the snow
against clogging the
outdoor.
• In installation, install
the anti-vibration rubber
between the unit and the
bracket.
The unit should be
installed at the place
where the cold/hot air or
noise will not interfere the
neighbours.