HAIMA M3 Series - A Pillar

To Next Page

To Previous Page

Replacement of Plates

IV-25

A Pillar

Removal (bilaterally symmetric, only left view provided)

• First drill on position (A) before removing the pillar, and remove the connecting piece between the lower side

panel and the front car body;

• Remove the upper and lower bolts (6 in total) from the inner side;

• Drill on position (B) and conduct rough cutting on position (C), and then remove the lower part on the outer side

of front pillar;

• Conduct rough cutting and drilling on area (D), and remove the reinforcement.

HAIMA M3 Series - A Pillar - Removal