Hakko Electronics FM2023-05 - Warnings, Cautions and Notes; Operational Safety Precautions; Unit Protection and Safe Environment

2
3. WARNINGS, CAUTIONS AND NOTES
Warnings, cautions and notes are placed at critical points in this manual to direct the
operator’s attention to signicant items. They are dened as follows:
WARNING:
 FailuretocomplywithaWARNINGmayresultininjuryordeath.
CAUTION:
 FailuretocomplywithaCAUTIONmayresultininjurytotheoperator,or
damagetotheitemsinvolved.(Oneexampleisgivenbelow.)
NOTE:
 ANOTEindicatesaprocedureorpointthatisimportanttotheprocessbeingde-
scribed.
CAUTION
Whenthepowerison,thetiptemperatureisbetween200°C/400°Fand400°C/750°F.
Sincemishandlingmayleadtoburnsorre,besuretocomplywiththefollowingpre-
cautions:
l
 Donottouchthemetallicpartsnearthetip.
l
 Donotusetheproductnearammableitems.
l
 Adviseotherpeopleintheworkareathattheunitcanreachaveryhightempera-
tureandshouldbeconsideredpotentiallydangerous.
l
 Turnoffthepowerwhiletakingbreaksandwhennishedusingtheunit.
l
 Beforereplacingpartsorstoringtheunit,turnoffthepowerandallowtheunitto
cooltoroomtemperature.
CAUTION
Topreventdamagetotheunitandensureasafeworkingenvironment,besureto
complywiththefollowingprecautions:
l
 Donotusetheunitforapplicationsotherthanthosespecicallydescribedinthe
instructionmanual.
l
 Donotsetthetiptemperaturehigherthan400°C/750°F.
l
 DonotraptheFM-2023againsttheworkbenchtoshakeoffresidualsolder,oroth-
erwisesubjecttheirontosevereshocks.
l
 Donotmodifytheunit.
l
 UseonlygenuineHAKKOreplacementparts.
l
 Donotwettheunitorusetheunitwhenyourhandsarewet.
l
 Theoperatingprocesswillproducesmoke.Makesuretheareaiswellventilated.
l
 PullontheplugtodisconnecttheFM-2023fromthestationoutlet.Donotpullthe
cord.