Hakko Electronics FM2023-05 - Operation Guide; Controls and Station Displays; Inserting Tips and Powering On

4
6. OPERATION
l
Controls and displays
RefertotheHAKKOFM-203orFM-206
instructionmanual.
NOTE:
TheHAKKOFM-203has2channels;Dand
S channel.The MODEL FM-2023 can be
connectedtoonlytheDchannel.
The HAKKO FM-206 has 3 channels: 1, 2
and3channel.TheMODELFM-2023canbe
connectedtoonlythechannel2.
RefertotheHAKKOFM-203/FM-206instruction
manualfordetailsofoperating.
There is a flange.
Make sure that the flange will
fit the handle when inserted
into the handpiece.
HAKKOFM-203
soldering station
NOTE:
Thetipsareasetof2pieceswiththesame
tipstyle.Theymustbeusedtogether.
l
Displays
1. Insertthetips:
 Holdtheheadpartofthetipwiththe
heat resistant pad and insert the tip
intothehandpiece.Pushuntilthetip
stops.Repeatforsecondtip.
2. TurnthepowerswitchON.
3. Whenthesettemperatureisreached,
thebuzzersounds.
ChannelD
displaylamp
ChannelS
displaylamp
ChannelD
connector
ChannelS
connector