Hama IR80MBT User Manual

17
PBC setup
Press the WPS button on your router or current access
point. This can often be done using the web interface, as
well.
Consult the operating instructions of your router or access
point for details.
Press and hold the WPS button (11) on the speaker for
approximately 3 seconds.
Once the process has been started on the router or access
point and the speaker, the speaker should be able to nd
and connect to the network.
16. Mono/Stereo mode
Mono speaker mode
Note
• Only one IR80MBT speaker is required to use it as a
mono speaker.
• Move the slide switch on the speaker (10) to the ST
position.
Stereo speaker mode
Two IR80MBT speakers are required to use them in stereo.
Set up the speakers to the left and right of the place where
you would like to sit.
Note
• Mind that the speakers are at the same height and
orientation towards you.
Move the slide switch (10) of the speaker on the left to the
L position.
Move the slide switch (10) of the speaker on the right to
the R position.
17. Display settings
Here you can nd all the most important information about
all network connections currently used or congured on
the radio, such as: MAC address, WLAN region, DHCP
active/disabled, SSID, IP address, subnet mask, gateway
address, DNS (primary and secondary), etc.
UNDOK App

Settings
17.1 Time settings
To access the time settings, proceed as follows:
UNDOK App
Settings

Set date & time
17.2 Language
The UNDOK app uses the language selected in your
smartphone’s system.
17.3 Factory settings
To reset the radio to the factory settings (delivery state), or
to switch to SETUP mode (re-open AP), proceed as follows:
(An explanation of the LED behaviour can be found in the
LED table).
a) Version 1 - Button combination on the device:
Press and hold the [RESET] button (12) for around 3
seconds.
b) Version 2 - Button combination on the device:
• E Disconnect the power pack from the device.
• Press and hold the [WPS] button (11) and insert the
power pack into the mains connection (14) at the same
time.
• Then press and also hold the [POWER] button (1) for
around 3 seconds. Ensure that all buttons are pressed
simultaneously. All buttons can then be released.
c) Variant 3 - Resetting via the UNDOK app:
UNDOK App
Settings

Factory reset
• Conrm the next prompt with YES to reset the radio to
the factory default settings.
All settings made previously are deleted.

Hama IR80MBT Specifications

General

Brand	Hama
Model	IR80MBT
Category	Radio
Language	English