Need help?Do you have a question about the Hameg HM 307 and is the answer not in the manual?
General| Type | Oscilloscope |
|---|---|
| Channels | 2 |
| Max Input Voltage | 400 V (DC + AC peak) |
| Trigger Modes | Auto, Normal, Single |
| Weight | 6.5 kg |
| Vertical Sensitivity | 5 mV/div to 20 V/div |
| Time Base | 0.2 μs/div to 0.5 s/div |
| Input Impedance | 1 MΩ |
| Trigger Sources | CH1, CH2, Line, Ext |
| Display | CRT |
| Power Supply | 50/60 Hz |
Detailed specifications for the vertical deflection system, including bandwidth and sensitivity.
Specifications for the timebase sweep and triggering functions.
Specifications for the integrated component testing feature.
Description of the measuring amplifier, attenuator, and drift compensation.
Description of the LPS technique, trigger signal, and voltage comparator.
Explanation of how to operate the component tester function.
Description of mains connection, earthing, isolation, and high voltage hazards.
Instructions for voltage setting, initial control configuration, and powering on the instrument.
Description of signal voltage types, bandwidth limitations, and AC/DC coupling.
Explanation of voltage measurement conventions (Vpp) and amplitude calculation.
Importance of trigger level, automatic triggering, and stable sweep generation.
Step-by-step guide for initial instrument setup and power-on.
Steps for adjusting brightness, focus, astigmatism, and troubleshooting common CRT issues.
Guidance on diagnosing faults using test equipment and sectional analysis.
To Next Page
