Need help?Do you have a question about the Hameg HM 203 and is the answer not in the manual?
General| Type | Oscilloscope |
|---|---|
| Bandwidth | 20 MHz |
| Channels | 2 |
| Trigger Modes | Auto, Normal, Single |
| Trigger Source | CH1, CH2, Line, Ext |
| Max Input Voltage | 400 V (DC + AC peak) |
| Display | CRT |
| Input Impedance | 1 MΩ |
| Power Supply | 100-240 V AC |
Bandwidth, risetime, deflection coefficients, input impedance, and coupling.
Calibrated steps, variable control, accuracy, and magnification.
Modes, slope, sources, coupling, threshold, and bandwidth.
Pushbutton usage, instrument protection, intensity limits, safety.
Isolation transformer, protective conductor, X-ray safety.
Converting peak-to-peak to RMS values, voltage designations.
Multiplying time coefficient by horizontal distance.
Measuring between 10% and 90% of vertical pulse height.
Verifying trace length, sweep speed accuracy.
Steps for removing chassis, high voltage hazards during repair.
Circuit diagram for low and high voltage power supply.
Guidance for unblanking pulse, VR3104, sweep rate, and trigger adjustments.
Diagram showing adjustment points for various controls.
To Next Page
