Hameg HM 1004-3.01 - User Manual

33 pages

Save Page as PDF

To Next Page

Instruments

MANUAL

Oscilloscopes

HM 1004-3 .01/.02/.03

HM 1505-3 .01/.02/.03

FRANKFURT

●●

● PARIS

●●

● LUTON

●●

● BARCELONA

●●

● NEW YORK

●●

● OCEANSIDE

●●

● HONG KONG

ENGLISH

Main Page

Table of Contents2
General Information Regarding the CE Marking3
General Information5
Symbols5
Use of Tilt Handle5
Safety5
Intended Purpose and Operating Conditions5
Emc6
Warranty6
Maintenance6
Protective Switch-Off6
Power Supply6
Type of Signal Voltage7
Amplitude Measurements7
Total Value of Input Voltage8
Time Measurements8
Connection of Test Signal9
Controls and Readout10
Menu20
First Time Operation20
Trace Rotation TR20
Probe Compensation and Use20
Adjustment at 1Khz21
Adjustment at 1Mhz21
Operating Modes of the Vertical Amplifiers in Yt Mode22
X-Y Operation22
Phase Comparison with Lissajous Figures22
In DUAL Mode (Yt)22
Phase Difference Measurement in DUAL Mode22
Measurement of Amplitude Modulation22
Phase Difference Measurement23
Triggering and Timebase24
Automatic Peak (Value) -Triggering24
Normal Triggering24
Slope24
Trigger Coupling25
Triggering of Video Signals25
Line Triggering (~)25
Alternate Triggering26
External Triggering26
Trigger Indicator "TR26
HOLD OFF-Time Adjustment26
B-Timebase (2Nd Timebase)/ Triggering after Delay27
Auto Set27
Save/Recall28
Component Tester28
General28
Using the Component Tester28
Test Procedure28
Test Pattern Displays28
Testing Resistors28
Testing Capacitors and Inductors28
Testing Semiconductors29
Testing Diodes29
Testing Transistors29
In-Circuit Tests29
Test Instructions30
General30
Cathode-Ray Tube: Brightness and Focus30
Linearity, Raster Distortion30
Astigmatism Check30
Symmetry and Drift of the Vertical Amplifier30
Check Vertical Amplifier30
Transmission Performance30
Of the Vertical Amplifier30
Operating Modes: CH.I/II, DUAL, ADD, CHOP ., INVERT and X-Y Operation31
Triggering Checks31
Timebase32
Holdoff Time32
Component Tester32
Trace Alignment32
Adjustments32
Safety32
Operation32
RS232 Interface - Remote Control33
Baud-Rate Setting33
Data Communication33
Front Panel HM1004-3/HM1505-333

Need help?

Do you have a question about the Hameg HM 1004-3.01 and is the answer not in the manual?

Hameg HM 1004-3.01 Specifications

General

Brand	Hameg
Model	HM 1004-3.01
Category	Test Equipment
Language	English

Related product manuals

Hameg HM 1004-3 Series

Hameg HM 1004-3.01 - User Manual

Table of Contents

Hameg HM 1004-3.01 Specifications

Related product manuals