Need help?Do you have a question about the Hameg HM 1004-3 Series and is the answer not in the manual?
General| Bandwidth | 100 MHz |
|---|---|
| Timebase | 5 ns/div - 2.5 s/div |
| Trigger Sources | CH1, CH2, Line |
| Input Impedance | 1 MΩ |
| Power Supply | 50 Hz / 60 Hz |
| Type | Analog Oscilloscope |
| Vertical Sensitivity | 2 mV/div to 10 V/div |
Details on EMC directive compliance and applied standards for safety.
Explains operational symbols, tilt handle use, and general handling advice.
Covers electrical safety, intended use, and environmental limits for operation.
Details EMC compliance, maintenance, warranty, and power supply information.
Describes DC/AC voltage, bandwidth, and input coupling for signals.
Explains how to perform voltage and time measurements using oscilloscope features.
Details the function of front panel buttons, knobs, and the display readout.
Explains Yt modes (Mono, DUAL, ADD) and X-Y operation for signal display.
Covers trigger modes, coupling, slope, and timebase controls for stable displays.
Guide for initial instrument setup, probe compensation, and calibration.
Explains how to measure phase differences and amplitude modulation.
Details using the built-in tester for analyzing resistors, capacitors, and semiconductors.
Information on setting up and using the serial interface for PC control.
To Next Page
