Hamilton Beach HBH755-CN

Questions and Answers

W
williamsmaryAug 12, 2025
What to do if my Hamilton Beach HBH755-CN Blender fails to start or stops while it is running and display is blank?
- A
  Aaron HarmonAug 12, 2025
  If your Hamilton Beach Blender fails to start or stops and the display is blank, check the following: * Ensure the Power Switch is in the ON (Reset) position and illuminated red. * Verify the unit is securely plugged into an electrical outlet with the correct voltage and frequency. * Check the fuse for the electrical outlet or if the Power Switch has tripped. * If the motor overheats, unplug the blender and let it cool for 15 minutes before plugging it back in.
C
Carolyn BryantAug 19, 2025
What to do if my Hamilton Beach HBH755-CN does not respond to button commands or an error message appears in the display?
- B
  bfisherAug 20, 2025
  If your Hamilton Beach Blender does not respond to button commands or displays an error message, try turning the power off and then back on using the power switch. This will reset the controls. If the error message continues to appear, the unit may require servicing.
S
Stephanie HahnAug 27, 2025
What to do if my Hamilton Beach HBH755-CN Blender fails to start or stops while it is running and a message appears in the display?
- M
  Michael ShawAug 27, 2025
  If your Hamilton Beach Blender fails to start or stops and a message appears on the display, ensure the jar is properly seated on the blender base. The blender will not operate unless the jar is correctly positioned. Also, make sure the Quiet Shield™ is down and in the correct position.
T
Timothy DuffySep 3, 2025
Why are ingredients not mixing properly in my Hamilton Beach Blender?
- R
  Rickey WilsonSep 3, 2025
  If ingredients are not mixing correctly in your Hamilton Beach Blender, consider the following: * Ensure enough liquid has been added, so the mixture is fluid. * Reduce the size of solid pieces. * Do not overfill the container past the highest graduation marking. * Check if the cutter assembly is installed correctly. * Select a speed that creates a fluid blend. Inspect the cutter assembly daily and replace it yearly or sooner if worn or damaged.