25
Upgrade
Upgrade allows the user to upgrade the print server device. In order to upgrade the unit
please perform the steps as follows:
1. Click Upgrade button just like a picture
, as shown as follow picture
2. Select General Upgrade. Make sure that the upgrade file is located in the same
directory as PSAdmin.
Reset
1. Click Reset button just like a picture .
2. Reset allows the user to reset the print server device in order to establish a new
connection or for new settings to take effect.
Refresh
1. Click Reset button just like a picture .
2. Refresh searches the network for all attached print server(s).
Note: Configure the print speed in the Advanced label, must match the printer’s speed
which connect to the print server. Undependable configuration will cause printer to
abnormal printing.
To Next Page
Loading...
Need help?
General
