44
TCP/IP Setup
1. Click Setup, it then appears the sub-menu.
2. Click TCP/IP, it then as shown in the following picture.
DHCP/BOOTP: This option allows you to select DHCP/ BOOTP option. If there is a
DHCP/BOOTP server on your network. This option allows the print server to obtain
IP-related settings automatically from your DHCP server.
IP Address: This option allows you to input IP address from the print server. The IP
address must meet the IP addressing requirements of the network segment.
Note: On the TCP/IP Setup screen, specify a fixed IP address is highly recommended.
Subnet Mask: This option allows you to input subnet mask from the print server. The IP
address must meet the IP addressing requirements of the network segment.
Default Router: This option allows you to input gateway from the print server. This IP
address of gateway must meet the router or gateway to go across of the network segment.
To Next Page
Loading...
Need help?
General
